Machine Installation - Ricoh J-P2 Service Manual

MACHINE INSTALLATION

1.4 MACHINE INSTALLATION
Refer to the Operating Instructions. If the customer has made a service contract,
change the settings of the following SP mode menus in accordance with it.
NOTE: 1) The meter charge mode must be enabled for any meter click counter
contract (☛ SP5-930-1).
2) One of the counter methods (developments/prints) must be selected in
accordance with the contract (☛ SP5-045-1).
3) The default of the meter-charge mode is "off."
4) The meter-charge counter cannot be reset.
Item SP No.
Meter SP5-930-1
charge
Counting SP5-045-1
method
A3/11" x 17" SP5-104-1
double
counting
Function
Specifies whether the meter charge mode is
enabled or disabled.
Meter charge mode enabled:
• The Counter menu appears immediately
after the Menu key is pressed.
• The counter type selected by the counting
method (SP5-045-1) can be displayed with
the Counter menu.
• The counter values can also be printed with
the Counter menu.
• The selected counter starts from a negative
number.
• When the ACS mode is on, a monochrome
page is counted as such even if it follows a
color page.
Meter charge mode disabled:
• The Counter menu is not displayed.
• The total counter starts from 0.
• When the ACS mode is on, a monochrome
page is counted as a color page if it follows
a color page.
NOTE: The menu items, "Show Counter" and
"Print," appear in the UP mode after
the meter charge mode (SP5-930-1) is
enabled or the optional CF expander
is installed. (These menu items
always appear after the CF expander
is installed.)
Specifies whether the counting method used
in meter charge mode is based on
developments or prints.
Important:
This SP can only be done before the negative
counters are reset with SP7-825-001.
Specifies whether the counter is doubled for
A3/11" x 17" paper.
1-8
17 January, 2003
Default
"OFF"
"0":
Developments
"No": Single
counting