Firmware Upgrade - Ricoh J-P2 Service Manual

FIRMWARE UPDATE – CF CONFIGURATION

5.8.3 FIRMWARE UPGRADE

"
CAUTION
3. Turn off the main switch whenever inserting or removing an IC card.
4. Do not turn off the machine while downloading the firmware.
1. Make sure that the main switch is turned off.
2. Remove the IC card cover [A].
3. Fully insert the IC card [B] containing the required
firmware into the IC card slot on the controller.
4. Turn on the main switch. The following message is
displayed. Then, press the button where the
firmware description is displayed.
5. Pressing the UpDate button starts
updating the firmware. To indicate the
progress, bars change to asterisks one
by one.
PCcard -> ROM Page01
ROM:G0775611C
Engine (1)
ROM:RB1.10:23
Exit (0)
- Engine - Scanner IPU
- Music - OpePanel.DOM
- Onboard Sys - Opt DIMM Fax
- Network Support
5-100
[A]
[B]
NEW:G0775611F
NEW:RB111C:23
New Version (IC Card)
Current Version
G080S511.WMF
PCcard -> ROM Page01
Engine (1)
Verify(./*)
PCcard -> ROM Page01
17 January, 2003
G080S912.WMF
ROM:G0775611C NEW:G0775611F
ROM:RB1.10:23 NEW:RB111C:23
Exit(0) UpDate(0)
G080S512.WMF
Loading
Engine
------------
G080S513.WMF