Ricoh J-P2 Service Manual page 29

NOTES FOR TRANSPORTING THE MACHINE
8. Attach shipping tape to the covers and doors, or shrink-wrap the machine
tightly.
NOTE: 1) If pre-installing machines for some test prints at a service depot, use a
jig oil supply unit, and not the oil supply unit enclosed as an accessory.
This is because the toner supply system uses a touch-and-release
mechanism, which can cause the unit to move freely up and down
during transport if shipping the mainframe with the oil supply unit
installed. This in turn may cause damage to the white holder on the
fusing unit. However if simply moving the machine from floor to floor, the
oil supply unit can be left installed.
2) If shipping a used machine to a new location, dispose of the used oil
supply unit and install a new one because of the reason explained
above. This is not necessary when simply moving the machine from
floor to floor.
3) Whenever having moved the machine to a new location, be sure to
perform Auto Adjust (User Program mode) or forced Line Position
Adjustment (SP5-993-002) to optimize color line alignment.
4) Make sure that the side fences in the trays are properly positioned to
prevent color shifting.
1-12
17 January, 2003