Ricoh J-P2 Service Manual page 242

PRINTER ENGINE SERVICE MODE
5
(Class 1, 2, and 3)
961 [Finisher Stack] Finisher Maximum Stack
1 Finisher Stack
970 [DebugSerial]
1 DebugSerial
971 [Touch Panel Correction] Touch Panel Correction Log
1 Touch Panel Calibration
974 [Cherry Server Setting}
1 Cherry Server Setting
981 [CSS Setup Call]
1 CSS Setup Call
[Loop Back Test]
989
1 Duplex
3 Finisher
4 PSU
[SP print mode]
990
1 SP all print
2 All
3 User Program
4 Logging
5 Diagnosis Report
990 6 Non-Default
7 NIB Summary
8 Net File Log
21 Copier User Program
22 Scanner SP
23 Scanner User Program
Mode No.
*BCU
#
*CTL [0 ~ 0xff / 0x00 / 0 /step] DFU
*
CTL
CF
*
CTL
CF
CF
CF
CF
CF
CF
CF
Function / [ Setting ]
Enables or disables maximum stack mode for the
lower shift tray only in staple mode.
If this is enabled, the upper tray can be
used for stacking 500 sheets but it stays
at the upper exit (will not be used for
stapling mode), and the lower tray is used
for stacking up to 2,000 sheets.
If this is disabled, the upper tray can be used for
stacking 500 sheets and the lower tray for 1,500
sheets.
[ 0 or 1 / 1 / - ]
0: Disabled
1: Enabled
NOTE: The main switch must be turned off and on
to effect the setting change.
Displays whether the touch panel has been
calibrated after clearing all memory.
[ 0 or 1 / 0 / - ]
0: Not calibrated
1: Calibrated
Specifies which version of ScanRouter, "Lite" or
"Full", is installed.
[ 0 or 1 / 0 / - ]
0: Lite
1: Full
DFU
Executes a communication test with peripherals
by using a special tool (connector) which is unique
for each peripheral.
The machine checks if the communication with the
peripherals is OK or NG; then displays the result.
DFU
Prints out the SMC sheets.
Prints out the SMC sheets.
5-54
17 January, 2003