Stapling - Ricoh J-P2 Service Manual

CONTROLLER

Stapling

Stapling is available when the two-tray finisher is installed.
The finisher has the following stapling positions.
• Depending on the paper orientation, the image may have to be rotated. The
driver rotates the image. If the paper cannot be physically stapled as specified by
the driver, it will not be stapled.
• There is a limit for the number of sheets which can be stapled. If a job has more
than this number, it will not be stapled.
For A3, 11" x 17", 8
For 8 " x 11", A4, B5 paper: 50 sheets
1/2
Punching
Punching is available only when the punch kit is installed with the two-tray finisher.
The number of holes (2, 3, or 4 holes) depends on the type of punch kit.
• There is only one punch position available, so the relationship between the
punching position and the printed image depends on the paper feed orientation
and image rotation.
2 Tray Finisher
Paper Feed Direction
(Printed side)
" x 14" paper: 30 sheets
1/2
2 Tray Finisher
Paper Feed Direction
(Printed side)
Stapled 2 places
Punching Position
6-88
17 January, 2003
G080D971.WMF
G080D972.WMF