Ricoh J-P2 Service Manual page 237

17 January, 2003
Mode No.
5
(Class 1, 2, and 3)
828 25 Software Switch
26 OperationMode:TCP/IP
27 SyslogServer Address
28 Timer Server Address
29 DNS Server Address
30 Directprint Port No
31 IPP Timeout
32 IPX Address: NW
33 Remote Printer No:NW
34 Software Switch: NW
35 Trans.Protocol PS NW
36 AppleTalk Module
37 Net No: AT
38 Object Name: AT
39 Apple Talk Type
40 Working Zone: AT
47 Job Analysis Timeout
48 Job Timeout
49 Noise Cancel
50 1284 Compatibility
51 Data Transfer
PRINTER ENGINE SERVICE MODE
Function / [ Setting ]
* Sets the reference for the network
CTL software.[ 00000000 to FFFFFFFFh / 00000000h /
CF 1 hex unit/step ]
Sets the TCP/IP operation mode for the
network.[ 00000000 to FFFFFFFFh / 00000000h /
1 hex unit/step ]
Sets the syslog server address for the
network.[ 00000000 to FFFFFFFFh / 7F000001h /
1 hex unit/step ]
Sets the timer server address for the
network.[ 00000000 to FFFFFFFFh / 00000000h /
1 hex unit/step ]
Sets the DNS server address for the
network.[ 00000000 to FFFFFFFFh / 00000000h /
1 hex unit/step ]
Sets the directprint port number for the
network.[ 1024 to 65535 / 9100 / 1/step ]
Sets the IPP timeout for the network.[ 30 to 65535
/ 900 / 1/step ]
Sets the IPX Address.
Sets the remote printer number for the network.[ 0
to 254 / 0 / 1/step ]
Sets the software switch for the network.[ 0000 to
FFFFh / 0003h / 1 hex unit/step ]
Sets the print server transport protocol for the
network.0001h: TCP & IPX0100h: TCP& IPX
(Priority: IPX)0102h: TCP Only (Priority:
TCP)0001h: IPX Only
Sets the AppleTalk module for the network.2:
EtherTalk Phase2
Sets the NetNo of the AppleTalk network.
Sets the object name of the AppleTalk Network.
Sets the AppleTalk type for the network.
Sets the AppleTalk working zone for the network.
Sets the Centronics job analysis timeout for the
network.
[ 0 to 4200 / 3 / 1 sec/step ]
Sets the Centronics job timeout for the network.
[ 0 to 4200 / 0 / 1 sec/step ]
Sets the noise cancel level for the network.
[ 4 to 7 / 4 / 1 clock/step ]
Switches Centronics IEEE1284 compatibility on/off
for the network.
[ 0 or 1 / 1 / - ]
0: Disabled, 1: Enabled
Selecting "0" disables bi-directional data
transmission.
Sets the Centronics transfer speed for the
network.
[ 0 or 1 / 1 / - ]
0: Slow, 1: Fast
If you select "0" there will be a 120
the STP signal to the data transfer. (With 1: Fast
there is no delay.)
5-49
µ
s delay from