Ricoh J-P2 Service Manual page 187

17 January, 2003
Component
Toner end sensor
Drum gear
position sensor
Waste oil sensor
Waste oil bottle
set sensor
Waste toner
sensor
NOTE: The CN numbers are the connector numbers on the BCU.
CN Condition
K: 209-A2
Y: 206-A7
C: 206-A4
M: 206-A1
K: 213-13
CMY: 210-B12
212-A13
212-A16
213-A4
ELECTRICAL COMPONENT DEFECTS
Toner near end may not be
Open
detected even when the toner near
end condition is satisfied.
Toner near end may be detected
Shorted even when the toner near end
condition is not satisfied.
Open SC440
Shorted
Waste oil near full message is
Open
displayed.
Waste oil near full message is not
displayed even when a waste oil
Shorted
near full condition exists, causing a
waste oil leak.
The message "Reset waste oil
Open bottle correctly" is displayed even
when it is set correctly.
The message "Reset waste oil
Shorted bottle correctly" is not displayed
even when it is not set correctly.
Waste toner near full message is
Open displayed, even when a waste toner
near full condition does not exist.
Waste toner near full message is
not displayed even when a waste
Shorted
toner near full condition exists,
causing waste toner leak.
4-65
Symptom