Cisco Desktop Collaboration Experience Installation; Set Up Cisco Desktop Collaboration Experience Dx600 Series Phone - Cisco DX650 Administration Manual

Step 10 Associate a user to a user group. This step assigns users a common list of roles and permissions that apply to
all users in a user group. Administrators can manage user groups, roles, and permissions to control the level
of access (and, therefore, the level of security) for system users. For example, you must add users to the
standard Cisco CCM End Users group so users can access Cisco Unified Communications Manager User
Options.
For more information, see the following sections in the Cisco Unified Communications Manager Administration
Guide:
• "End user settings" section in the "End user setup" chapter
• "Add users to access control groups" section in the "Access control group setup" chapter
Step 11 (Optional) Associate a user with a phone. This step provides users with control over their phone such a
forwarding calls or adding speed-dial numbers or services.
Some phones, such as those in conference rooms, do not have an associated user.
For more information, see the "Associate devices to end user" section in the "End user setup" chapter in the
Cisco Unified Communications Manager Administration Guide.

Cisco Desktop Collaboration Experience Installation

After you add phones to the Cisco Unified Communications Manager database, you can complete the phone
installation. You (or the phone users) can install the phone at the user location.
Note Before you install a phone, even if it is new, upgrade the phone to the current firmware image. For
information about upgrading, see the readme file for your phone, which is located at:
http://tools.cisco.com/support/downloads/go/Redirect.x?mdfid=278875240
After the phone connects to the network, the phone startup process begins, and the phone registers with
Cisco Unified Communications Manager. To finish installing the phone, configure the network settings on
the phone depending on whether you enable or disable DHCP service.
If you used autoregistration, you need to update the specific configuration information for the phone, such as
associating the phone with a user, changing the button table, or changing the directory number.

Set Up Cisco Desktop Collaboration Experience DX600 Series Phone

The following steps provide an overview and checklist of installation tasks for the Cisco Desktop Collaboration
Experience DX600 Series phone. The steps present a suggested order to guide you through the phone
installation. Some tasks are optional, depending on your system and user needs. For detailed procedures and
information, see the sources in the steps.
Procedure
Step 1 Choose the power source for the phone:
• Power over Ethernet (PoE)
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
Cisco Desktop Collaboration Experience Deployment
29