Danfoss ECL Comfort 210 Operating Manual page 78

Operating Guide ECL Comfort 210/296/310, application A237/A337
MENU > Settings > Optimization
Parallel operation
Choose whether the heating circuit is to operate parallel to the DHW circuit.
See Appendix "Parameter ID overview"
OFF:
DHW heating has 100% priority. The heating circuit
circulation pump is OFF during DHW heating.
1 ... 99 K: Dependent parallel operation. The heating circuit
circulation pump is ON if the difference between DHW
heating temperature (charging temperature) and
desired flow temperature is less than the set value.
ON: Parallel operation. The heating circuit circulation pump
is ON during DHW heating.
MENU > Settings > Optimization
Summer, cut-out (limit for heating cut-out)
See Appendix "Parameter ID overview"
The heating can be switched OFF when the outdoor temperature is
higher than the set value. The valve closes and after the post-run
time, the heating circulation pump stops. 'Temp. min. ' will be
overruled.
The heating system switches ON again when the outdoor
temperature and the accumulated (filtered) outdoor temperature
become lower than the set limit.
This function can save energy.
Set the value for outdoor temperature at which you want the
heating system to switch OFF.
78 | © Danfoss | 2017.05
1x043
= Time
X
= Temperature
Y
= Acceptable deviation (Parallel operation, 1x043)
# 1#
# 2 # = Desired DHW heating temperature
# 3 # = Actual DHW heating temperature
# 4 # = 100% parallel operation
# 5 # = 100% DHW priority
Summer, cut-out
1x179
= Time
X
= Temperature
Y
= Actual outdoor temperature
# 1#
# 2 # = Cut-out temperature (1x179)
# 3 # = Accummulated (filtered) outdoor temperature
# 4 # = Heating enabled
# 5 # = Heating disabled
The heating cut-out is only active when the controller mode is in
scheduled operation. When the cut-out value is set to OFF, there is
no heating cut-out.
VI.LG.R3.02