Danfoss ECL Comfort 210 Operating Manual page 130

Operating Guide ECL Comfort 210/296/310, application A237/A337
ECA MENU > ECA factory > ECA clear apps.
Erase all apps. (Erase all applications)
Erase all applications which are in the ECA 30 / 31.
After erasing, the application can be uploaded again.
NO: The erase procedure is not done.
YES: The erase procedure is done (await 5 sec.).
ECA MENU > ECA factory > ECA default
Restore factory
The ECA 30 / 31 is set back to factory settings.
Affected settings by the restore procedure:
• Room T offset
• RH offset (ECA 31)
• Backlight
• Contrast
• Use as remote
• Slave addr.
• Connection addr.
• Override addr.
• Override circuit
• Override mode
• Override mode end time
NO: The restore procedure is not done.
YES: The restore procedure is done.
130 | © Danfoss | 2017.05
After the erase procedure, a pop-up in the display indicates "Copy
application". Choose "Yes".
Hereafter the application is uploaded from the ECL controller. An
upload bar is shown.
VI.LG.R3.02