Configuring Hafm Server Network Information - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

2. HP recommends connecting the remaining end of the Ethernet cable to the
3. Optionally, connect the HAFM server and managed switch products to their

Configuring HAFM Server Network Information

Verify the type of LAN installation with the customer's network administrator. If
the HAFM server is installed on a dedicated LAN, the network information does
not require change. If this is the case, go to
Time" on page 42.
If the HAFM server is installed on a public LAN segment, the following TCP/IP
network information must be changed to conform to the customer's LAN
addressing scheme:
Note:
allocated automatically using DHCP.
HAFM Server for Windows 2000 Installation Guide
LAN as follows:
a. If the HAFM server is installed on a customer-supplied private corporate
LAN segment, connect the cable to the LAN as directed by the customer's
network administrator.
b. If the HAFM server is installed on the HP-supplied Ethernet hub, connect
the cable to any available hub port.
own dedicated private LAN supplied by the customer, or to another Ethernet
hub as follows:
a. Connect one end of a customer-supplied Ethernet patch cable to the RJ-45
connector of the Ethernet adapter card installed in the PCMCIA slot at the
right side of the HAFM server (labeled Private LAN Interface, as shown
in Figure 3).
b. Connect the remaining end of the Ethernet cable to the dedicated private
LAN or hub, as directed by the customer's network administrator.
IP address.
Subnet mask.
Gateway address—the address of the local router for the corporate intranet.
DNS host name.
DNS domain name.
At some customer installations, TCP/IP addresses for the HAFM server may be
HAFM Server Setup and Configuration
"Setting the HAFM Server Date and
27