IQ 100 Series Mechanical Installation
Introduction
IQ 100 Series meter can be installed using a standard ANSI C39.1 (4" Round) or an IEC 92mm DIN
(Square) form. In new installations, simply use existing DIN or ANSI punches. For existing panels, pull
out old analog meters and replace with the IQ 100 Series meter. The various models use the same
installation. See the next chapter for wiring diagrams.
Meter Face
Meter Back
•
Recommended Tools for IQ 100 Series meter Installation: #2 Phillips screwdriver, Small wrench and
Wire cutters. Transducer Installation doesn't require any tools.
•
Mount the meter in a dry location, which is free from dirt and corrosive substances. The meter is
designed to withstand harsh environmental conditions (see Specifications earlier in the manual).
Meter Dimensions
ANSI Mounting
Rods - screw-in
DIN
Mounting
Brackets
ANSI Mounting Panel Cut-out
User and Installation Manual IM02601003E - July 2010 www.eaton.com
IQ 100 Series ((130/140/150) Meter
Mechanical Installation
Transducer Dimensions
DIN Mounting Cut-out
17