Table of Contents
Advertisement
Batch Mode Beep
When scanning in
Inventory Batch Mode
(page 3-16), the scanner beeps every time a bar code is scanned. When Batch
Mode Beep is On, you will also hear a click when each bar code is sent to the host. If you do not want to hear these clicks,
scan Batch Mode Beep Off. Default = Batch Mode Beep On.
Batch Mode Beep Off
* Batch Mode Beep On
Batch Mode Storage
When a scanner is storing data during a Batch Mode process, you can select whether the data is stored in Flash memory
or in RAM.
Flash Storage: The scanner writes any untransmitted data to flash memory prior to powering down. The data will still be
there when the scanner powers back up. However, the scanner will power down, even with untransmitted data, if it reaches
a power down timeout or if the battery power is very low.
RAM Storage: The scanner will not power down while it contains data that has not been transmitted to the host or Access
Point, even if it reaches a power down timeout. However, if the scanner runs out of battery power, it will power down and
the data will be lost.
Default = Flash Storage.
* Flash Storage
RAM Storage
Batch Mode Quantity
When in Batch Mode, you may wish to transmit the number of multiple bar codes scanned, rather than a single bar code
multiple times. For example, if you scan three bar codes called XYZ with Batch Mode Quantity Off, when you transmit
your data it will appear as XYZ three times. Using Batch Mode Quantity On and the Quantity Codes
(page
3-19), you
could output your data as "XYZ, 00003" instead.
Note: If you wish to format your output, for example, place a CR or tab between the bar code data and the quantity, refer
to
Data Formatting
beginning on page 6-1.
Default = Batch Mode Quantity Off.
* Batch Mode Quantity Off
3 - 17
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
Advertisement
Table of Contents
Troubleshooting
