Canon imageRUNNER ADVANCE C255 Series Service Manual page 777

COPIER (Service mode for copier) > OPTION (Specification setting mode) > IMG-FIX
FXS-TMP5 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
FXS-TMP6 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
FXST2-N2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Image leading edge control temp: thin
To set the offset of image leading edge control temperature for thin paper (60 to 63 g/m2).
As the value is incremented by 1, the control temperature is increased by 5 deg C from the specified
value.
Increase the value when a fixing failure occurs on the leading edge of paper.
Decrease the value when uneven gloss occurs on the leading edge (56.5 mm).
When uneven gloss occurs on the leading edge (56.5 mm) of thin paper
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Be sure to change the value a little at a time. Otherwise, offset/image failure occurs when setting
an extreme value.
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Image leading edge control temp:envelope
To set the offset of image leading edge control temperature for envelope.
As the value is incremented by 1, the control temperature is increased by 5 deg C from the specified
value.
Increase the value when a fixing failure occurs on the leading edge of paper.
Decrease the value when uneven gloss occurs on the leading edge (56.5 mm).
When uneven gloss occurs on the leading edge (56.5 mm) of envelope
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Be sure to change the value a little at a time. Otherwise, offset/image failure occurs when setting
an extreme value.
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Set of ITOP wait time:Plain ppr in LL Ev
To set initial rotation time when plain paper 1/2/3 is fed with a temperature lower than 10 deg C.
Increase the value when a fixing failure occurs.
When a fixing failure occurs in an environment where temperature is lower than 10 deg C
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
As the value is increased, (as the initial rotation time becomes longer), FCOT is increased.
0 to 20
second
0
1
766
8. Service Mode