Canon imageRUNNER ADVANCE C255 Series Service Manual page 632

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > CCD
GAIN3CL0 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
GAIN4CL0 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
LED3CL 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
LED3CL2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
LED4CL 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Adj CIS gain level: back,clr mode,300dpi
To adjust the detection level (gain level) of the Scanner Unit (Back) in color mode with 300 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 255
0
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS gain level: back,clr mode,600dpi
To adjust the detection level (gain level) of the Scanner Unit (Back) in color mode with 600 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 255
0
COPIER> FUNCTION> CCD> CL-AGC
Adj pry lgt src lgt time:back,clr,300dpi
To adjust the lighting time of the LED which is the primary light source of the Scanner Unit (Back)
in color mode with 300 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 2928
1648
COPIER> FUNCTION> CCD> CL-AGC
Adj sec lgt src lgt time:back,clr,300dpi
To adjust the lighting time of the LED which is the secondary light source of the Scanner Unit (Back)
in color mode with 300 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 2928
1648
COPIER> FUNCTION> CCD> CL-AGC
Adj pry lgt src lgt time:back,clr,600dpi
To adjust the lighting time of the LED which is the primary light source of the Scanner Unit (Back)
in color mode with 600 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 2928
2816
COPIER> FUNCTION> CCD> CL-AGC
621
8. Service Mode