COPIER (Service mode for copier) > ADJUST (Adjustment mode) > HV-TR
2TR-EN-1
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
2TR-EN-2
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
2TR-P-1
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
2TR-P-2
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Sec trn ATVC ctrl ppr allot V: envlp 1st
To adjust the paper allotted voltage applied to the 1st side of envelope at secondary transfer ATVC
control.
When mottled image occurs, increase the value if it is due to insufficient secondary transfer current
and decrease the value if it is due to overcurrent.
When adjusting the secondary transfer bias individually according to paper type and 1st/2nd side
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-128 to 127
V
0
30
Sec trn ATVC ctrl ppr allot V: envlp 2nd
To adjust the paper allotted voltage applied to the 2nd side of envelope at secondary transfer ATVC
control.
When mottled image occurs, increase the value if it is due to insufficient secondary transfer current
and decrease the value if it is due to overcurrent.
When adjusting the secondary transfer bias individually according to paper type and 1st/2nd side
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-128 to 127
V
0
30
Sec trn ATVC ctrl ppr allot V: crd 1st
To adjust the paper allotted voltage applied to the 1st side of postcard at secondary transfer ATVC
control.
When mottled image occurs, increase the value if it is due to insufficient secondary transfer current
and decrease the value if it is due to overcurrent.
When adjusting the secondary transfer bias individually according to paper type and 1st/2nd side
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-128 to 127
V
0
30
Sec trn ATVC ctrl ppr allot V: crd 2nd
To adjust the paper allotted voltage applied to the 2nd side of postcard at secondary transfer ATVC
control.
When mottled image occurs, increase the value if it is due to insufficient secondary transfer current
and decrease the value if it is due to overcurrent.
When adjusting the secondary transfer bias individually according to paper type and 1st/2nd side
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-128 to 127
V
0
30
671
8. Service Mode