Canon imageRUNNER ADVANCE C255 Series Service Manual page 597

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > CCD
100-RG 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
100-GB 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
100DF-RG 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
RG clr displc correct: front, vert scan
To correct the color displacement between R and G lines in vertical scanning direction due to the
Scanner Unit (Front).
When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB, enter the value of the service label on the reader.
When replacing the Scanner Unit (Front), enter the value of service label on a new unit.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB
- When replacing the Scanner Unit (Front)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-256 to 256
line
0
0.001
GB clr displc correct: front, vert scan
To correct the color displacement between G and B lines in vertical scanning direction due to the
Scanner Unit (Front).
When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB, enter the value of the service label on the reader.
When replacing the Scanner Unit (Front), enter the value of service label on a new unit.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB
- When replacing the Scanner Unit (Front)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-256 to 256
line
0
0.001
RG clr displc crrct:DADF,front,vert scan
To correct the color displacement between R and G lines in vertical scanning direction due to the
Scanner Unit (Front) that occurs at DADF reading with 600 dpi.
When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB, enter the value of the service label on the reader.
When replacing the Scanner Unit (Front), enter the value of service label on a new unit.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB
- When replacing the Scanner Unit (Front)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-256 to 256
line
0
0.001
586
8. Service Mode