Canon imageRUNNER ADVANCE C255 Series Service Manual page 483

30-0123
A. Operation / B. Cause /
C. Remedy
30-0124
A. Operation / B. Cause /
C. Remedy
30-0137
A. Operation / B. Cause /
C. Remedy
31-0006
A. Operation / B. Cause /
C. Remedy
31-0008
A. Operation / B. Cause /
C. Remedy
31-0010
A. Operation / B. Cause /
C. Remedy
31-0020
A. Operation / B. Cause /
C. Remedy
31-0030
A. Operation / B. Cause /
C. Remedy
31-0040
A. Operation / B. Cause /
C. Remedy
31-0106
A. Operation / B. Cause /
C. Remedy
Current values at 2 points were not changed with primary transfer ATVC control for cyan.
-
Current values at 2 points were not changed with primary transfer ATVC control for black.
-
The value of data for correcting high voltage output value was not within the range.
-
HDD failure when equipped with the mirroring function
HDD failure when equipped with the mirroring function
HDD failure prediction alarm
Movement: HDD failure is expected to occur in a short time due to occurrence of physical error in
HDD. It does not occur in the HDD of mirroring configuration.
Cause: Error in the S.M.A.R.T. value of HDD
Measures:
1. Back up the data stored in HDD.
2. Replace the HDD.
3. Restore the data.
S.M.A.R.T. (Self-Monitoring Analysis and Reporting Technology): Self-diagnosis function built in
the HDD. The occurrence rate of reading error, reading and writing speed, the total number of
Motor start-up and stop times, the total length of power-on time, etc. are monitored.
The configuration of an option controlled by the Main Controller has been changed
A change in configuration of an option such as a change in the configuration of the Fax Board, a
change in the configuration of the Voice Board, or a change in the configuration of the option HDD,
which requires turning OFF and then ON the power, was detected.
Detection condition/timing:At the time of startup only
Remedy:Turn OFF and then ON the main power.
The configuration of an option controlled by the RCON has been changed
Due to a change in the configuration related to the scanner, a change in the hardware configuration
which requires turning OFF and then ON the power was detected.
Detection condition/timing:At the time of startup only
Remedy:Turn OFF and then ON the main power.
The configuration of an option controlled by the DCON has been changed
Due to a change in the configuration related to the printer, a change in the hardware configuration
which requires turning OFF and then ON the power was detected.
Detection condition/timing:At the time of startup only
Remedy:Turn OFF and then ON the main power.
Communication with RTC was not available.
Cause: Communication with RTC could not be established.
Detection condition/timing:
- When a communication error occurred with RTC
Movement/symptom:
- FCOT may become longer.
Measures:
1. Check the connector/cable connected to the J109 Main Switch.
2. Check the Main Switch.
3. Replace the DC Controller PCB.
For R&D
472
7. Error/Jam/Alarm