Canon imageRUNNER ADVANCE C255 Series Service Manual page 730

COPIER (Service mode for copier) > OPTION (Specification setting mode) > FNC-SW
AMSOFFSW
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Additional Functions
Mode
Supplement/Memo
DMAX-DAY
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
UA-OFFSW
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
1 Enabling of AMS mode
To enable the AMS mode.
When 0 is set, the AMS mode is enabled. The AMS mode is automatically enabled when the
following 2 conditions are satisfied.
- AMS license for an iR option is installed.
- AMS-supported Login application (User Authentication, etc.) is activated.
When enabling AMS mode
1) Check that AMS-supported Login application is activated.
2) Enter 0, and then press OK key.
3) Turn OFF/ON the main power switch.
4) Check that [Role Management] is displayed on remote UI.
0 to 1
0: AMS mode enabled, 1: AMS mode disabled
1
COPIER> OPTION> LCNS-TR> ST-AMS
(Remote UI) User Management> Authentication Management> Role Management
AMS: Access Management System
In AMS mode, [Role Management] is displayed on remote UI.
1 Set D-max control execution frequency
To set the frequency of D-max control that is executed after a specified number of sheets is fed.
When 0 is set, the execution frequency of D-max control is decreased by half.
When density varies at the time of making a large number of outputs
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Half, 1: Normal
1
1 ON/OFF of unified auth function
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set ON/OFF of the Unified Authentication function.
Set 0 when not preferring to use the Unified Authentication function because of security concern.
Upon user's request (not to use the Unified Authentication function)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: ON, 1: OFF
0
Unified Authentication: A function with which it is considered that login authentication under it is
performed by logging in it using SSO-H.
719
8. Service Mode