Canon imageRUNNER ADVANCE C255 Series Service Manual page 724

COPIER (Service mode for copier) > OPTION (Specification setting mode) > FNC-SW
FXWRNLVL 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
KSIZE-SW 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
PDF-RDCT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SJB-UNW 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Set Fix Film life display threshold VL
To set the threshold value to display the life of Fixing Film.
This item is enabled when the value at the following is set to "1" (default: 0): COPIER> OPTION>
DSPLY-SW> FXMSG-SW (ON/OFF of Fixing Assembly replacement message)
The life judgment counter is stored in the DC Controller. It is not possible to change or check the
counter value.
When preventing the occurrence of fixing failure caused by the continuous use of the Fixing Film
beyond its life
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 3
0: Warning is hidden.
1: Warning is displayed when the life counter reaches the specified value.
2. Warning is displayed when the print counter reaches the specified value.
3: Warning is displayed when either the life counter or the print counter reaches the specified value.
0
COPIER> OPTION> DSPLY-SW> FXMSG-SW
ON/OFF of Chinese paper (K-size) display
To set whether to display Chinese paper (K-size paper: 16K) as an original size at the time of
copying or scan and store.
When MODEL-SZ is 0, this setting is enabled.
When using K size paper
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: OFF, 1: ON
It differs according to the location.
COPIER> OPTION> FNC-SW> MODEL-SZ
16K paper: 270 x 195 mm
PDF reduction set at forwarding
To set whether to reduce the image for transmission when converting the image received by IFAX
into PDF for e-mail/file transmission.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Following the current setting, 1: Image reduction
0
Reserve upper limit of secured print job
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the upper limit for the number of reserved jobs in secured print job.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2
0: 50 jobs, 1: 90 jobs, 2: No limit
1
713
8. Service Mode