Commissioning; The Built-In Basic Operator Panel (Bop) - Siemens Sinamics V20 Operating Instructions Manual

3

Commissioning

For more information about parameters, faults, and alarms, refer to Appendix A of the English or Chinese version of this
document.
3.1

The built-in Basic Operator Panel (BOP)

V V
Button functions
Stops the inverter
Single press
Double press (< 2 s) or
long press ( > 3 s)
Starts the inverter in HAND / JOG mode.
Multi-function button
M M
Short press ( < 2 s)
Long press ( > 2 s)
Short press ( < 2 s)
OK OK
Long press ( > 2 s)
Press to switch between HAND (with hand icon) / JOG (with flashing hand icon) / AUTO (no icon)
+
M M OK OK
mode.
Note: Jog mode is only available if the motor is stopped.
● Moves the selection up through a menu, increases a value or a setpoint.
● Long press (>2 s) to quickly scroll up the values.
● Moves the selection down through a menu, decreases a value or a setpoint.
● Long press (>2 s) to quickly scroll down the values.
Reverses the direction of rotation of the motor.
+
Inverter status icons
Inverter has at least one pending fault.
Inverter has at least one pending alarm.
:
(flashing):
Motor rotates in the reversed direction.
:
(flashing):
10
A A Hz Hz 1/min kW 1/min kW % %
M M OK OK
OFF1 stop reaction in HAND mode.
OFF2 stop reaction: the inverter allows the motor to coast to a standstill
without using any ramp-down timings.
● Enters the parameter setting menu or moves to the next screen
● Restarts the digit by digit editing on the selected item
● Press twice in digit by digit editing to discard change and return
● Returns to the status screen
● Enters the setup menu
● Switches between status values
● Enters edit value mode or change to the next digit
● Clears faults
● Quick parameter number or value edit
Inverter is running (motor frequency may be 0 rpm).
Inverter may be energized unexpectedly (for example, in frost protection mode).
Inverter is in HAND mode.
Inverter is in JOG mode.
Getting Started
A5E31842771, 02/2013