Table of Contents
Advertisement
12
SERVICE WORK ON THE CHASSIS
12.5
Removing the fork protector
12.6
Installing the fork protector
12.7
Removing the fork legs
Warning
Danger of accidents Oil or grease on the brake discs reduces the brak-
ing effect.
–
–
–
Clean and oil the dust boots and inner fork tubes of both fork legs.
Universal oil spray (
–
Press the dust boots back into their normal position.
–
Remove excess oil.
Finishing work
–
Install the fork protector. (
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Remove screws
–
Remove screws
F00316-10
–
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
–
Position the fork protector on the right fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
F00316-11
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
Main work
–
Remove screws
–
Remove the cable tie(s).
–
Remove screws
–
Allow the brake caliper and brake line to hang loosely to the side.
F00274-10
Always keep the brake discs free of oil and grease.
Clean the brake discs with brake cleaner when necessary.
p. 118)
p. 46)
and take off the clamp.
on the left fork leg and take off the left fork protector.
on the right fork leg and take off the right fork protector.
(
p. 80)
and take off the clamp.
and take off the brake caliper.
p. 45)
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 89)
p. 45)
46
.
.
.
Hide quick links:
Advertisement
Table of Contents
