Changing The Mapping; Adjusting The Idle Speed - Husqvarna FE 450 Owner's Manual

17 TUNING THE ENGINE
17.4

Changing the mapping

Warning
Voiding of the government approval for road use and the insurance coverage If the combination switch is installed,
the vehicle's approval for road use is invalidated.
–
Only operate the vehicle in closed-off areas remote from public road traffic if the combination switch is installed.
Info
The desired engine characteristic can be activated via the MAP button on the combination switch.
The setting most recently selected is activated again when restarting.
The traction control can also be activated in each mapping using the TC button.
The mapping can also be changed during the ride.
17.5

Adjusting the idle speed

Warning
Danger of accidents The engine may go out spontaneously if the idle speed is set too low.
–
Set the idle speed to the specified value. (Your authorized Husqvarna Motorcycles workshop will be glad to help.)
Activating STANDARD mapping:
–
Press button MAP until LED 1 lights up.
Guideline
Engine speed
STANDARD – balanced response
H01180-10
Activating ADVANCED mapping:
–
Press button MAP until LED 2 lights up.
Guideline
Engine speed
ADVANCED – direct response
H01180-11
–
Run the engine until warm.
The cold start button is deactivated – The cold start button is in its basic
position. (
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and death.
–
–
–
Set the idle speed by turning idle speed adjusting screw
Guideline
Idle speed
Tachometer (45129075000)
F00448-10
p. 17)
Always make sure there is sufficient ventilation when running the
engine.
Use an effective exhaust extraction system when starting or running
the engine in an enclosed space.
< 4,000 rpm
< 4,000 rpm

.
1,800... 1,900 rpm
99