Installing The Lower Triple Clamp - Husqvarna FE 450 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.10

Installing the lower triple clamp

3 0 0 3
2 0 0 2
1 0 0 1
Main work
–
Open the cable holder in front of the right radiator and detach the wiring harness.
–
Remove screws
–
Open the cable holder in front of the left radiator and detach the wiring harness.
F00277-10
–
Remove screw
–
Remove screw
–
Take off the upper triple clamp with the handlebar and set it aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
F00279-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
F00278-10
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Position the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
–
Check whether upper steering head seal
–
Mount protective ring
B01632-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
F00279-11

and hang the voltage regulator to the side.

.

.
 
and protective ring
p. 118)
 
and O-ring

but do not tighten yet.
.

is correctly positioned.
.
48