Electrical System; Removing The Battery; Installing The Battery - Husqvarna FE 450 Owner's Manual

15

ELECTRICAL SYSTEM

15.1

Removing the battery

Warning
Risk of injury Batteries contain harmful substances.
–
Keep batteries out of the reach of children.
–
Keep sparks and open flames away from the batteries.
–
Only charge batteries in well-ventilated rooms.
–
Maintain a minimum clearance from inflammable materials when charging batteries.
Minimum clearance
–
Do not charge deeply discharged batteries if charge is already below the minimum voltage.
Minimum voltage before the start of the charge
–
Dispose of batteries with less than the minimum voltage correctly.
15.2

Installing the battery

Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the air filter box cover. (
–
Remove the seat. (
Main work
–
Pull back the negative terminal cover
the battery.
–
Pull back the positive terminal cover
the battery.
–
Remove screw
–
Pull holding bracket
H01190-10
Main work
–
Insert the battery into the battery compartment with the terminals facing forward
and secure with holding bracket
Battery (HJTZ5S-FP) (
–
Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Contact disks
ets
–
Connect positive cable
Guideline
Screw, battery terminal
H00388-10
1 m (3 ft)
9 V
p. 56)
p. 55)

 .

forward and remove battery toward the top.

.
p. 114)

.

must be mounted under screws

with the claws toward the battery terminal.

to the battery.

and disconnect negative cable
and disconnect positive cable
M6 10 Nm (7.4 lbf ft)

and cable sock-
M5 2.5 Nm
(1.84 lbf ft)
85

from

from