18
SERVICE WORK ON THE ENGINE
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
F00442-11
–
Position long oil screen
–
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
–
Push the oil screen all the way into the engine case.
F00444-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten oil drain plug
Guideline
Oil drain plug with magnet
F00445-10
–
Remove screws
F00440-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surface.
F00446-10
–
Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Insert the new oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
F00440-11
with the short oil screen and the O-rings.
with the O-rings on a pin wrench.
with the O-ring.
with the magnet and a new seal ring.
. Remove the oil filter cover with the O-ring.
out of the oil filter housing.
M20x1.5
15 Nm (11.1 lbf ft)
M20x1.5
15 Nm (11.1 lbf ft)
M12x1.5
20 Nm (14.8 lbf ft)
M6
10 Nm (7.4 lbf ft)
104
.