12
SERVICE WORK ON THE CHASSIS
12.8
Installing the fork legs
12.9
Removing the lower triple clamp
–
Loosen screws
–
Loosen screws
F00275-10
Main work
–
Position the fork legs.
Bleeder screws
Info
The compression damping is located in left fork leg COM (white adjusting
screw). The rebound damping is located in right fork leg REB (red adjust-
ing screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
402556-10
upper triple clamp.
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
F00275-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
F00276-10
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove the handlebar cushion.
. Take out the left fork leg.
. Take out the right fork leg.
are positioned toward the front.
.
M8
.
M8
M8
(
p. 80)
p. 91)
p. 45)
(
p. 80)
(
p. 46)
p. 51)
17 Nm (12.5 lbf ft)
15 Nm (11.1 lbf ft)
.
25 Nm
Loctite
®
243™
(18.4 lbf ft)
p. 90)
p. 89)
47
.