Husqvarna FE 450 Owner's Manual page 51

12 SERVICE WORK ON THE CHASSIS
-
Secure wiring harness and clutch line with cable holder.
-
Position the voltage regulator, and mount and tighten screws
Guideline
Remaining screws, chassis
-
Secure the wiring harness with the cable holder in front of the right radiator.
F00373-10
-
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB (red adjusting
screw). The compression damping is located in left fork leg COM (white
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
H01672-10
-
Tighten screws
Guideline
Screw, bottom triple clamp
F00318-11
-
Tighten screw
Guideline
Screw, top steering head
F00281-10
-
Mount and tighten screw
Guideline
Screw, top steering stem
F00281-11
-
Tighten screws
Guideline
Screw, top triple clamp
F00318-10

are positioned toward the front.

.

.

.
M8

.

.
M6 10 Nm (7.4 lbf ft)
M8 15 Nm (11.1 lbf ft)
M20x1.5 12 Nm (8.9 lbf ft)
17 Nm Loctite
(12.5 lbf ft)
M8 17 Nm (12.5 lbf ft)
49
® 243™