Table of Contents
Advertisement
17
TUNING THE ENGINE
17.6
Teaching the throttle valve position
Info
If the control unit detects that the throttle valve idle position needs to be retaught, then the malfunction indicator lamp
flashes 2x per second.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when running the engine.
–
Use an effective exhaust extraction system when starting or running the engine in an enclosed space.
–
Allow the vehicle to idle.
The malfunction indicator lamp stops flashing once teaching is completed.
Info
If the engine becomes too hot, perform a cool-down ride at medium revs.
Then do not switch off the engine after this, but leave it running at idle speed until teaching is completed.
17.7
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the driver's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
17.8
Adjusting the basic position of the shift lever
Info
Turning counterclockwise lowers the idle speed.
Turning clockwise raises the idle speed.
–
Sit on the vehicle in the riding position and determine the distance
the upper edge of your boot and the shift lever.
Gap between the shift lever and the
top of the boot
»
If the distance does not meet the specifications:
–
Adjust the basic position of the shift lever.
400692-10
–
Remove screw
401950-12
–
Clean gear teeth
–
Mount the shift lever on the shift shaft in the required position and engage the
gearing.
Info
The range of adjustment is limited.
The shift lever must not come into contact with any other vehicle compo-
nents during the shift procedure.
401951-10
with washers and take off shift lever
of the shift lever and shift shaft.
10... 20 mm (0.39... 0.79 in)
(
p. 100)
.
100
between
Hide quick links:
Advertisement
Table of Contents
