Changing The Hydraulic Clutch Fluid - Husqvarna FE 450 Owner's Manual

Table of Contents

Advertisement

12
SERVICE WORK ON THE CHASSIS
12.44

Changing the hydraulic clutch fluid

Warning
Skin irritation Brake fluid causes skin irritation.
Keep brake fluid out of the reach of children.
Wear suitable protective clothing and safety glasses.
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
Consult a doctor immediately if brake fluid has been swallowed.
Rinse the affected area with plenty of water in the event of contact with the skin.
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact with the eyes.
If brake fluid spills on to your clothing, change the clothing.
Warning
Environmental hazard Hazardous substances cause environmental damage.
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and clutch lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
Remove screws
Remove cover
F00311-10
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 (
On the clutch slave cylinder, remove bleeder screw
syringe
F00454-10
Now inject the fluid into the system until it emerges from drill hole
ter cylinder without bubbles.
Now and then, extract fluid from the master cylinder reservoir to prevent overflow.
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
Position the cover with the membrane. Mount and tighten the screws.
F00324-10
Info
Clean up overflowed or spilled brake fluid immediately with water.
.
with membrane
with the appropriate hydraulic fluid.
p. 117)
.
.
and mount bleeding
4 mm (0.16 in)
69
of the mas-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fe 501

Table of Contents