Table of Contents
Advertisement
12
SERVICE WORK ON THE CHASSIS
12.42
Adjusting the basic position of the clutch lever
12.43
Checking/correcting the fluid level of the hydraulic clutch
Warning
Skin irritation Brake fluid causes skin irritation.
–
Keep brake fluid out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
–
Consult a doctor immediately if brake fluid has been swallowed.
–
Rinse the affected area with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact with the eyes.
–
If brake fluid spills on to your clothing, change the clothing.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
The fluid level rises with increasing wear of the clutch facing discs.
–
Check that screw
Guideline
Screw, fixed grip
Diamond
F00323-10
–
Adjust the basic setting of the clutch lever to your hand size by turning adjusting
screw
.
Info
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance
between the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
F00310-10
Do not make any adjustments while riding!
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level below container rim
»
If the level of the fluid does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
F00311-10
Brake fluid DOT 4 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilled brake fluid immediately with water.
is firmly seated.
M4
must be located at the top.
.
with membrane
p. 117)
5 Nm
Loctite
(3.7 lbf ft)
.
4 mm (0.16 in)
68
®
243™
Hide quick links:
Advertisement
Table of Contents
