Eaton XV-102 Operating Instructions Manual page 53

3 If a cord gasket has not been glued inside groove (A) at the back of the device's front plate already,
insert the enclosed gasket cord into groove (A) and cut it to length in such a way that there is no
gap at the joint.
CAUTION
Poor sealing
Poor sealing resulting from the twisting of the sealing strip or due to a gap between
the ends of the sealing strip.
The join of the sealing strip must be positioned on the bottom of the device.

Do not twist the sealing strip when it is inserted.

Cut the sealing strip to a suitable length so that the join is tight.

Fig.. 30 Groove for sealing strip (A)
4 Fit the supplied threaded pins in the retaining brackets beforehand.
The tips of the threaded pins must point towards the wider ends of the retaining brackets.

Fig.. 31 Set screw pre-assembled in holding bracket
5 Insert the device into the mounting cutout from the front.
6 Clip on the retaining brackets in the recesses provided for them on the device as shown below and
fix the device by tightening the threaded pins until the front of the MICRO PANEL is flush with the
surface of the control cabinet at the fixing points.
HMI/PLC XV-102 08/2016 MN04802004Z-EN www.eaton.com
5 Installation
5.4 Mounting
53