Mounting - Eaton XV-102 Operating Instructions Manual

5.4

Mounting

CAUTION
Interference
The values specified in the technical data and the device's electromagnetic compat-
ibility (EMC) cannot be guaranteed if unsuitable cables, improperly assembled and
terminated cables, and/or unprofessional wiring are used.
Only use cables prefabricated and terminated by professionals.

The cables being used must be assembled and terminated as required by the

port/interface description in this document.
When wiring the device, follow all instructions regarding how to wire the corre-

sponding port/interface.
All general Directives and standards must be complied with.

CAUTION
Condensation in/on the device
If the device is or was exposed to climatic changes (temperature fluctuation, air hu-
midity) moisture can form on or in the device (device condensation). In this case,
there is a risk of short-circuit.
The device must not be switched on when device condensation is present.

If the device has condensation in or on it, or if the device has been exposed to

temperature fluctuations, let the device settle into the existing ambient air tem-
perature before switching it on (do not expose the device to direct thermal radia-
tion from heating appliances).
1 Check the device for transit damage.

The device must only be installed and commissioned in perfect technical condition and
in compliance with this document.
2 Mount the device in the control cabinet, control panel or the control desk. See chapter 5.4.1
Mounting the device,  52
3 Connect the device as required for your application.
Follow the instructions on wiring the relevant interface. See chapter 5.3 Interfaces,  27


The device does not have an ON/OFF switch. The device is not provided with an On/Off
switch. If the power supply is not provided with a switch, the device will start up (boot)
as soon as it is connected to the power supply.
HMI/PLC XV-102 08/2016 MN04802004Z-EN www.eaton.com
5 Installation
5.4 Mounting
51