Dell Z9000 Configuration Manual page 679

Sending updates every 30 seconds, next due in 17
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface Recv Send
GigabitEthernet 2/42 2 2
GigabitEthernet 2/41 2 2
GigabitEthernet 2/31 2 2
GigabitEthernet 2/11 2 2
Routing for Networks:
10.300.10.0
10.200.10.0
10.11.20.0
10.11.10.0
Routing Information Sources:
Gateway Distance
10.11.20.1 120
Distance: (default is 120)
Core2#
RIP Configuration on Core3
The following example shows how to configure RIPv2 on a host named Core3.
Example of Configuring RIPv2 on Core3
Core3(conf-if-gi-3/21)#router rip
Core3(conf-router_rip)#version 2
Core3(conf-router_rip)#network 192.168.1.0
Core3(conf-router_rip)#network 192.168.2.0
Core3(conf-router_rip)#network 10.11.30.0
Core3(conf-router_rip)#network 10.11.20.0
Core3(conf-router_rip)#show config
!
router rip
network 10.0.0.0
network 192.168.1.0
network 192.168.2.0
version 2
Core3(conf-router_rip)#
Core 3 RIP Output
The examples in this section show the core 2 RIP output.
• To display Core 3 RIP database, use the show ip rip database command.
• To display Core 3 RIP setup, use the show ip route command.
• To display Core 3 RIP activity, use the show ip protocols command.
Example of the show ip rip database Command to View Learned RIP Routes on Core 3
Example of the show ip routes Command to View RIP Setup on Core 3
Example of the show ip protocols Command to Show RIP Configuration Activity on Core 3
Core3#show ip rip database
Total number of routes in RIP database: 7
Routing Information Protocol (RIP)
Last Update
00:00:12
679