Sflow On Lag Ports; Enabling Extended Sflow - Dell Z9000 Configuration Manual

As a result of back-off, the actual sampling-rate of an interface may differ from its configured sampling
rate. You can view the actual sampling-rate of the interface and the configured sample-rate by using the
show sflow command.

sFlow on LAG ports

When a physical port becomes a member of a LAG, it inherits the sFlow configuration from the LAG port.

Enabling Extended sFlow

The S-Series platforms support extended-switch information processing only.
Extended sFlow packs additional information in the sFlow datagram depending on the type of sampled
packet. You can enable the following options:
• extended-switch — 802.1Q VLAN ID and 802.1p priority information.
• extended-router — Next-hop and source and destination mask length.
• extended-gateway — Source and destination AS number and the BGP next-hop.
NOTE: The entire AS path is not included. BGP community-list and local preference information are
not included. These fields are assigned default values and are not interpreted by the collector.
• Enable extended sFlow.
sflow [extended-switch] [extended-router] [extended-gateway] enable
By default packing of any of the extended information in the datagram is disabled.
• Confirm that extended information packing is enabled.
show sflow
Example of Verifying Extended sFlow is Enabled
Example of Verifying Extended sFlow Disabled
The bold line shows that extended sFlow settings are enabled on all three types.
Dell#show sflow
sFlow services are enabled
Global default sampling rate: 4096
Global default counter polling interval: 15
Global extended information enabled: gateway, router, switch
1 collectors configured
Collector IP addr: 10.10.10.3, Agent IP addr: 10.10.0.0, UDP port: 6343
77 UDP packets exported
0 UDP packets dropped
165 sFlow samples collected
69 sFlow samples dropped due to sub-sampling
Linecard 1 Port set 0 H/W sampling rate 8192
Gi 1/16: configured rate 8192, actual rate 8192, sub-sampling rate 1
Gi 1/17: configured rate 16384, actual rate 16384, sub-sampling rate 2
Linecard 3 Port set 1 H/W sampling rate 16384
Gi 3/40: configured rate 16384, actual rate 16384, sub-sampling rate 1
If you did not enable any extended information, the show output displays the following (shown in bold).
Dell#show sflow
sFlow services are disabled
750
sFlow