Dell Z9000 Configuration Manual page 509

technique is less effective as traffic increases because preemptive load balancing requires prior
knowledge of traffic distributions.
• lack of scalable register decasulation: With only a single RP per group, all joins are sent to that RP
regardless of the topological distance between the RP, sources, and receivers, and data is transmitted
to the RP until the SPT switch threshold is reached.
• slow convergence when an active RP fails: When you configure multiple RPs, there can be
considerable convergence delay involved in switching to the backup RP.
Anycast RP relieves these limitations by allowing multiple RPs per group, which can be distributed in a
topologically significant manner according to the locations of the sources and receivers.
1. All the RPs serving a given group are configured with an identical anycast address.
2. Sources then register with the topologically closest RP.
3. RPs use MSDP to peer with each other using a unique address.
Figure 77. MSDP with Anycast RP
Multicast Source Discovery Protocol (MSDP)
509