Enabling Graceful Restart - Dell Z9000 Configuration Manual

– Number: 1 through 10.
Format: IP Address: A.B.C.D.
You must Configure Peer Groups
Example of Viewing AS Numbers in AS Paths
The lines shown in bold are the number of times ASN 65123 can appear in the AS path (allows–in 9).
To disable this feature, use the no neighbor allow-as in number command in CONFIGURATION
ROUTER BGP mode.
R2(conf-router_bgp)#show conf
!
router bgp 65123
bgp router-id 192.168.10.2
network 10.10.21.0/24
network 10.10.32.0/24
network 100.10.92.0/24
network 192.168.10.0/24
bgp four-octet-as-support
neighbor 10.10.21.1 remote-as 65123
neighbor 10.10.21.1 filter-list Laura in
neighbor 10.10.21.1 no shutdown
neighbor 10.10.32.3 remote-as 65123
neighbor 10.10.32.3 no shutdown
neighbor 100.10.92.9 remote-as 65192
neighbor 100.10.92.9 local-as 6500
neighbor 100.10.92.9 no shutdown
neighbor 192.168.10.1 remote-as 65123
neighbor 192.168.10.1 update-source Loopback 0
neighbor 192.168.10.1 no shutdown
neighbor 192.168.12.2 remote-as 65123
neighbor 192.168.12.2 allowas-in 9
neighbor 192.168.12.2 update-source Loopback 0
neighbor 192.168.12.2 no shutdown
R2(conf-router_bgp)#R2(conf-router_bgp)#

Enabling Graceful Restart

Use this feature to lessen the negative effects of a BGP restart.
Dell Networking OS advertises support for this feature to BGP neighbors through a capability
advertisement. You can enable graceful restart by router and/or by peer or peer group.
NOTE: By default, BGP graceful restart is disabled.
The default role for BGP is as a receiving or restarting peer. If you enable BGP, when a peer that supports
graceful restart resumes operating, Dell Networking OS performs the following tasks:
• Continues saving routes received from the peer if the peer advertised it had graceful restart capability.
Continues forwarding traffic to the peer.
• Flags routes from the peer as Stale and sets a timer to delete them if the peer does not perform a
graceful restart.
• Deletes all routes from the peer if forwarding state information is not saved.
• Speeds convergence by advertising a special update packet known as an end-of-RIB marker. This
marker indicates the peer has been updated with all routes in the local RIB.
196
before assigning it to an AS.
Border Gateway Protocol IPv4 (BGPv4)