Dell Z9000 Configuration Manual page 611

Dell(conf-mon-sess-0)#show c
!
monitor session 0
source TenGigabitEthernet 0/0 destination TenGigabitEthernet 0/1 direction rx
Dell(conf-mon-sess-0)#
Dell(conf-mon-sess-0)#do show monitor session
SessID Source
------ ------
0 Te 0/0
Dell(conf)#monitor session 0
Dell(conf-mon-sess-0)#source po 10 dest ten 0/1 dir rx
Dell(conf-mon-sess-0)#do show monitor session
SessID Source
------ ------
0 Te 0/0
0 Po 10
Dell(conf)#monitor session 1
Dell(conf-mon-sess-1)#source vl 40 dest ten 0/2 dir rx
Dell(conf-mon-sess-1)#flow-based enable
Dell(conf-mon-sess-1)#exit
Dell(conf)#do show monitor session
SessID Source
------ ------
0 Te 0/0
0 Po 10
1 Vl 40
Note: Source as VLAN is achieved via Flow based mirroring. Please refer section
Monitoring.
In the following example, the host and server are exchanging traffic which passes through the uplink
interface 1/1. Port 1/1 is the monitored port and port 1/42 is the destination port, which is configured to
only monitor traffic received on tengigabitethernet 1/1 (host-originated traffic).
Port Monitoring
Destination Dir
------------ ---
Te 0/1 rx
Destination Dir
----------- ---
Te 0/1 rx
Te 0/1 rx
Destination Dir
----------- ---
Te 0/1 rx
Te 0/1 rx
Te 0/2 rx
Mode Source IP
---- ---------
Port N/A
Mode Source IP
---- ---------
Port N/A
Port N/A
Mode Source IP
---- ---------
Port N/A
Port N/A
Flow N/A
Dest IP
--------
N/A
Dest IP
--------
N/A
N/A
Dest IP
--------
N/A
N/A
N/A
Enabling Flow-Based
611