Dell Z9000 Configuration Manual page 133

10/25/40/50/100gbe throughput

Hide thumbs Also See for Z9000:

Table of Contents

You can configure only two of these features at a time.

To allocate the number of FP blocks for VLAN open flow operations, use the cam-acl-vlan

vlanopenflow <0-2> command.

To allocate the number of FP blocks for VLAN iSCSI counters, use the cam-acl-vlan vlaniscsi

<0-2> command.

To allocate the number of FP blocks for ACL VLAN optimization feature, use the cam-acl-vlan

vlanaclopt <0-2> command.

To reset the number of FP blocks to the default, use the no version of these commands. By default, zero

groups are allocated for the ACL in VCAP. ACL VLAN groups or CAM optimization is not enabled by

default, and you need to allocate the slices for CAM optimization.

To display the number of FP blocks that is allocated for the different VLAN services, you can use the show

cam-acl-vlan command. After CAM configuration for ACL VLAN groups is performed, reboot the

system to enable the settings to be stored in nonvolatile storage. During the initialization of CAM, the

chassis manager reads the NVRAM and allocates the dynamic VCAP regions.

Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)

Troubleshooting