Dell Z9000 Configuration Manual page 246

NDP Packets
Neighbor discovery protocol has 4 types of packets NS, NA, RA, RS. These packets need to be taken to
CPU for neighbor discovery.
• Unicast NDP packets:
– Packets hitting the L3 host/route table and discovered as local terminated packets/CPU bound
traffic. For CPU bound traffic route entry have CPU action. Below are packets are CPU bound
traffic.
* Packets destined to chassis.
* Route with Unresolved Arp
* Unknown traffic in IP Subnet range
* Unknown traffic hitting the default route entry.
• Multicast NDP packets
– NDP packets with destination MAC is multicast
* DST MAC 33:33:XX:XX:XX:XX
• NDP Packets in VLT peer routing enable
– VLT peer routing enable cases each VLT node will have route entry for link local address of both
self and peer VLT node. Peer VLT link local entry will have egress port as ICL link. And Actual link
local address will have entry to CopyToCpu. But NDP packets destined to peer VLT node needs to
be taken to CPU and tunneled to the peer VLT node..
• NDP packets in VLT peer routing disable case
– NDP packets intended to peer VLT chassis taken to CPU and tunnel to peer.
Redirecting Control Traffic to 12 CPU queues
The following table describes the protocol to queue mapping with the CPU queues increased to be 12.
CPU Weights
Queue
0 100
1 1
2 2
3 4
246
Rate (pps)
1300 BFD
300 MC
300 TTL0, TTL1, IP with
options, Mac limit
violation, Hyper pull, L3
with Bcast MacDA,
Unknown L3, ARP
unresolved, ACL Logging
400 sFlow, L3 MTU Fail
frames
Protocol
Control Plane Policing (CoPP)