Dell Z9000 Configuration Manual page 49

Table 3. Forming a
copy
Location
Internal flash: primary RPM
Internal flash: standby RPM
External flash: primary RPM
External flash: standby RPM
For a remote file location:
FTP server
For a remote file location:
TFTP server
For a remote file location:
SCP server
Important Points to Remember
• You may not copy a file from one remote system to another.
• You may not copy a file from one location to the same location.
• The internal flash memories on the route processor modules (RPMs) are synchronized whenever there
is a change, but only if both RPMs are running the same version of Dell Networking OS.
• When copying to a server, you can only use a hostname if a domain name server (DNS) server is
configured.
• The usbflash command is supported on Z9000. Refer to your system's Release Notes for a list of
approved USB vendors.
Example of Copying a File to an FTP Server
Example of Importing a File to the Local System
Dell#copy flash://FTOS-EF-8.2.1.0.bin ftp://myusername:mypassword@10.10.10.10/
/FTOS/FTOS-EF-8.2.1.0
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
27952672 bytes successfully copied
core1#$//copy ftp://myusername:mypassword@10.10.10.10//FTOS/
FTOS-EF-8.2.1.0.bin flash://
Destination file name [FTOS-EF-8.2.1.0.bin.bin]:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
26292881 bytes successfully copied
Getting Started
Command
source-file-url Syntax
copy flash://filename
copy rpm{0|1}flash://
filename
copy rpm{0|1}slot0://
filename
copy rpm{0|1}slot0://
filename
copy ftp://
username:password@{hostip
| hostname}/filepath/
filename
copy tftp://{hostip |
hostname}/filepath/
filename
copy scp://{hostip |
hostname}/filepath/
filename
destination-file-url Syntax
flash://filename
rpm{0|1}flash://filename
rpm{0|1}slot0://filename
rpm{0|1}slot0://filename
ftp://
username:password@{hostip
| hostname}/ filepath/
filename
tftp://{hostip |
hostname}/filepath/
filename
scp://{hostip |
hostname}/filepath/
filename
49