Dell Z9000 Configuration Manual page 414

Distribute Routes
Another method of controlling routing information is to filter the information through a prefix list.
Prefix lists are applied to incoming or outgoing routes and routes must meet the conditions of the prefix
lists or Dell Networking OS does not install the route in the routing table. The prefix lists are globally
applied on all interfaces running IS-IS.
Configure the prefix list in PREFIX LIST mode prior to assigning it to the IS-IS process. For configuration
information on prefix lists, refer to
Applying IPv4 Routes
To apply prefix lists to incoming or outgoing IPv4 routes, use the following commands.
NOTE: These commands apply to IPv4 IS-IS only. To apply prefix lists to IPv6 routes, use ADDRESS-
FAMILY IPV6 mode, shown later.
• Apply a configured prefix list to all incoming IPv4 IS-IS routes.
ROUTER ISIS mode
distribute-list prefix-list-name in [interface]
– Enter the type of interface and slot/port information:
– For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port
information.
– For the Loopback interface on the RPM, enter the keyword loopback then a number from 0 to
16383.
– For a port channel, enter the keywords port-channel then a number.
– For a SONET interface, enter the keyword sonet then the slot/port information.
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
– For a VLAN, enter the keyword vlan then a number from 1 to 4094.
• Apply a configured prefix list to all outgoing IPv4 IS-IS routes.
ROUTER ISIS mode
distribute-list prefix-list-name out [bgp as-number | connected | ospf
process-id | rip | static]
You can configure one of the optional parameters:
– connected: for directly connected routes.
– ospf process-id: for OSPF routes only.
– rip: for RIP routes only.
– static: for user-configured routes.
– bgp: for BGP routes only.
• Deny RTM download for pre-existing redistributed IPv4 routes.
ROUTER ISIS mode
distribute-list redistributed-override in
414
Access Control Lists (ACLs).
Intermediate System to Intermediate System