Dell Z9000 Configuration Manual page 109

Viewing Prefix Lists
To view all configured prefix lists, use the following commands.
• Show detailed information about configured prefix lists.
EXEC Privilege mode
show ip prefix-list detail [prefix-name]
• Show a table of summarized information about configured Prefix lists.
EXEC Privilege mode
show ip prefix-list summary [prefix-name]
Example of the show ip prefix-list detail Command
Example of the show ip prefix-list summary Command
Dell>show ip prefix detail
Prefix-list with the last deletion/insertion: filter_ospf
ip prefix-list filter_in:
count: 3, range entries: 3, sequences: 5 - 10
seq 5 deny 1.102.0.0/16 le 32 (hit count: 0)
seq 6 deny 2.1.0.0/16 ge 23 (hit count: 0)
seq 10 permit 0.0.0.0/0 le 32 (hit count: 0)
ip prefix-list filter_ospf:
count: 4, range entries: 1, sequences: 5 - 10
seq 5 deny 100.100.1.0/24 (hit count: 0)
seq 6 deny 200.200.1.0/24 (hit count: 0)
seq 7 deny 200.200.2.0/24 (hit count: 0)
seq 10 permit 0.0.0.0/0 le 32 (hit count: 0)
Dell>
Dell>show ip prefix summary
Prefix-list with the last deletion/insertion: filter_ospf
ip prefix-list filter_in:
count: 3, range entries: 3, sequences: 5 - 10
ip prefix-list filter_ospf:
count: 4, range entries: 1, sequences: 5 - 10
Dell>
Applying a Prefix List for Route Redistribution
To pass traffic through a configured prefix list, use the prefix list in a route redistribution
command.
Apply the prefix list to all traffic redistributed into the routing process. The traffic is either forwarded or
dropped, depending on the criteria and actions specified in the prefix list.
To apply a filter to routes in RIP, use the following commands.
• Enter RIP mode.
CONFIGURATION mode
router rip
• Apply a configured prefix list to incoming routes. You can specify an interface.
If you enter the name of a nonexistent prefix list, all routes are forwarded.
CONFIG-ROUTER-RIP mode
Access Control Lists (ACLs)
109