Configuring Fp Blocks For Vlan Parameters - Dell Z9000 Configuration Manual

4. Add VLAN member(s) to an ACL VLAN group.
CONFIGURATION (conf-acl-vl-grp) mode
member vlan {VLAN-range}
5. Display all the ACL VLAN groups or display a specific ACL VLAN group, identified by name.
CONFIGURATION (conf-acl-vl-grp) mode
show acl-vlan-group {group name | detail}
Dell#show acl-vlan-group detail
Group Name :
TestGroupSeventeenTwenty
Egress IP Acl :
SpecialAccessOnlyExpertsAllowed
Vlan Members :
100,200,300
Group Name :
CustomerNumberIdentificationEleven
Egress IP Acl :
AnyEmployeeCustomerElevenGrantedAccess
Vlan Members :
2-10,99
Group Name :
HostGroup
Egress IP Acl :
Group5
Vlan Members :
1,1000
Dell#

Configuring FP Blocks for VLAN Parameters

Use the cam-acl-vlan command to allocate the number of FP blocks for the various VLAN processes
on the system. You can use the no version of this command to reset the number of FP blocks to default.
By default, 0 groups are allocated for the ACL in VCAP. ACL VLAN groups or CAM optimization is not
enabled by default, and you need to allocate the slices for CAM optimization.
1. Allocate the number of FP blocks for VLAN Open Flow operations.
CONFIGURATION mode
cam-acl-vlan vlanopenflow <0-2>
2. Allocate the number of FP blocks for VLAN iSCSI counters.
CONFIGURATION mode
cam-acl-vlan vlaniscsi <0-2>
3. Allocate the number of FP blocks for ACL VLAN optimization feature.
CONFIGURATION mode
cam-acl-vlan vlanaclopt <0-2>
130
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)