How To Find Enc Chart Manufacturer Info; How To Install C-Map Charts; How To Register The Etoken - Furuno FMD-3200 Operator's Manual

3.5

How to Find ENC Chart Manufacturer Info

The ENC chart manufacturer information shows if your installed ENC charts are offi-
cial or unofficial. To find this information, use the [Producer Code] button in the [Li-
censes] dialog box. The following functions use this feature.
• [Filter] window (see section 3.15) can show or hide official
or unofficial charts.
• Unofficial charts are denoted on the [Check Results] of the
[Route Plan] dialog box (see section 9.4.5) if the corresponding alert check is active.
1. In the Chart maintenance mode, click the [License] button to show the [Licenses]
dialog box.
2. Click the [ENC] tab.
3. Click the [Producer Code] button.
4. Select the ENC chart manufacturer information file then click the [Open] button.
5. Reset the power.
3.6

How to Install C-MAP Charts

Synchronize chart data before you install C-MAP charts, grouping the ECDIS units to
synchronize, otherwise the chart data cannot be shared. See the procedure in
section 3.22.1 for how to synchronize chart data. If C-MAP charts are not synchro-
nized after installation, delete all C-MAP charts, and do the above procedure again.
3.6.1

How to register the eToken

The eToken is a hardware mechanism (installed inside the PCU) used for password
authentication. Registration of the eToken is required only once, before you install the
C-MAP database.
1. Get into the Chart maintenance mode then click the [License] button on the
InstantAccess bar
™
to show the [Licenses] dialog box.
3. HOW TO MANAGE CHARTS
Official:
Official Unofficial
3-9