Control Unit Backlighting - Furuno FMD-3200 Operator's Manual

1. INTRODUCTION
Manual brilliance adjustment with the trackball module
1. Click the [BRILL] button on the InstantAccess bar™ to show the brilliance adjust-
ment window.
2. For coarse adjustment, put the cursor on a location within the slider bar area
then push the left button. For fine adjustment, put the cursor on the end of the
slider bar and roll the trackball while holding down the left button.
3. Release the left button to confirm setting. The calibration state indication changes
to "UNCALIB".
4. Click the [CALIB] button to calibrate the brilliance. The calibration state indication
changes to "CALIB".
1.8.2

Control unit backlighting

Put the cursor on the backlighting setting, and up and down arrows appear. Click the
arrows to adjust the backlighting.
1-8
Current backlighting
level
Backlight setting
range
Click arrows to set
backlighting.