Furuno FMD-3200 Operator's Manual page 359

If...
ENC chart cannot be
displayed
past track is not
displayed
monitored user chart
is not displayed on
ECDIS display
route monitoring is
stopped
user chart is not dis-
played on radar
overlay
message "Nearing
memory usage limit.
Click the Restart
button to restart the
system to prevent
trouble."
appears
message "Nearing
memory usage limit.
If you will start moni-
toring, click the Re-
start button to restart
the system to pre-
vent trouble during
route monitoring."
message "Memory
usage limit reached.
Click the Restart
button to restart the
system to prevent
trouble."
appears.
some Display mode
buttons are yellow
then...
• no ENC chart for area.
• dongle is not connected.
• past track is not selected to be vis-
ible.
• user chart is not selected to be vis-
ible.
• Alert 691: RM Stop - Exceed Max
XTE. Own ship is too far away
from the route.
• Alert 692: No Valid Sensor Data.
ECDIS internal error.
• Alert 693: RM Stop - Other
Causes. Required data (position,
SOG/COG) not found.
• user chart is not selected in Voy-
age navigation mode.
• the memory usage limit for soft-
ware is close to capacity. Perfor-
mance may be affected.
• the memory usage limit for soft-
ware is close to capacity. Perfor-
mance may be affected.
• the memory usage limit for soft-
ware is reached. Performance
may be affected.
• the memory usage limit for soft-
ware is close to capacity. Perfor-
mance may be affected.
24. MAINTENANCE AND TROUBLESHOOTING
• Open ENC chart from [Manage
Charts] dialog box.
• Connect dongle.
• Open [Tracking] page of [Symbol
Display] menu and select [Own
Ship Past Tracks] to [CCRP], [Pri-
mary], [Secondary] or [Pivot] as
appropriate.
• Open [Mariner] page of [Symbol
Display] menu and select parts to
show.
• Steer the ship back to the route
then restart route monitoring.
• Request service.
• Check sensor connections.
• Select user chart in Voyage navi-
gation mode.
• If you need to save your work, click
the [Later] button then reset the
power. If you don't need to save
your work, click the [Restart] but-
ton.
Note that the notice does not ap-
pear in the Conning mode.
• Click the [Restart] button.
• Click the [Restart] button to reset
the power. No other operations are
available other than restart.
Note that the notice does not ap-
pear in the Conning mode.
• Stop all operations and reset the
power.
Remedy
24-5