Safety Information - Picotest M3510A User Manual

using the equipment at once.
Do not use the Meter around explosive gas or inflammable vapor.
Wipe the surface of M3510A multimeter with a piece of dry and clean
cloth.

1.5 Safety Information

Caution! Please read through the following safety information
before using the product.
To avoid possible electric shock or personal injury, please read and follow
these guidelines carefully:
Follow the guidelines in this manual and DO NOT use the Meter if the
case is damaged. Check the Meter case and terminals, and make sure
all the devices are in the proper positions.
Do not apply excessive voltage to the Multimeter. Apply voltage
within the rated range only.
Use caution when measuring voltages above 30 V RMS, 42 V peak, or
60 V DC. These voltages pose an electric shock hazard.
When using the probes, always keep your fingers behind the finger
guards.
Always connect the common test leads (black) before connecting the
live test leads (red), and disconnect the live test leads (red) before
disconnecting the common test leads (black). This will reduce the
chance of an electric shock.
Disconnect circuit power and discharge all high-voltage capacitors
before testing resistance, continuity, diodes or capacitance.
If you need to open the Meter case or replace any parts, read the
instruction in this manual first. You must be a qualified personnel to
perform this action.
When replacing fuses, use only the same type and same rating as
specified.
Do not try to operate the Meter if it is damaged. Disconnect the power
from the equipment and consult the local service representative.
Return the product to PICOTEST service department if necessary.
9 9 9 9