Beeper - Picotest M3510A User Manual

DISPlay:TEXT <quoted string> (displays the string you type in)
DISPlay:TEXT:CLEar

4.4.2 Beeper

M3510A/11A beeps when some certain conditions are met or when an
error occurs. But there may be time you want to disable the beeper for
some operations. Although you can turn off the beeper, the click sound
you hear when a button is pressed will not be disabled. The beeper state
is stored in a non-volatile memory and the default will be restored when
the meter has been turned off or after a remote interface reset.
By disabling the beeper you will not hear the meter beeps when
A new minimum or maximum is found in Min/Max operation
A stable reading is detected and held
The test voltage is within the limits in diode testing
The source signal fails the limit testing.
After the beeper is disabled, the meter still emits a tone when:
An error occurs
Any button on the front panel is pressed
The threshold value is exceeded in continuity testing.
Default
The beeper is enabled when it is shipped from the factory.
How to control the beeper
You can control the beeper from either the front panel operation or the
remote interface operation.
Front Panel Operation
Do the procedure SHIFT + CONFIG > SYSTEM > BEEP > ON/OFF >
ENTER to enable or disable the beep.
(clears the message displayed)
.
77 77 77 77
.
.
.
: : : :
.