Trigger Operations - Picotest M3510A User Manual

can set the address to any value from 0 and 31, and the setting will be
stored in the non-volatile memory. The address is set to "22" when the
multimeter is shipped from the factory.
Note: The remote interface can only be set through the front panel
※
operations.
How to select a remote interface
1. Press SHIFT + CONFIG buttons. Then use
locate "INTERFACE". Press ENTER to select it.
2. Use and
◁ ▷
ENTER on your choice of interface.
How to set address when using GPIB
1. Press SHIFT + CONFIG buttons, and then use
locate "INTERFACE". Press ENTER to select.
2. Use and
◁ ▷
3. Use and
◁ ▷
buttons to adjust the numbers to a desired GPIB address. Press
ENTER to set the address.

4.2 Trigger Operations

In this section we will discuss the triggering system in M3510A/11A.
M3510A/11A provides a variety of trigger operations. You can select a
trigger mode, a trigger source and different trigger settings for a specific
measurement. The defined selection is stored in a volatile memory and
the default settings will be restored after power-off. Figure 4-1 shows
the trigger operation in M3510A/11A.
buttons to toggle between "USB" and "GPIB". Press
buttons to locate "GPIB". Press ENTER to select it.
b uttons to move through the digits and
59 59 59 59
and buttons to
◁ ▷
and buttons to
◁ ▷
△
a nd
▽